Description
- Package Includes: (1)RockvilIe MRCA25 25 Foot Twisted Pair Marine RCA Cable 100% Copper, Split Pin. (2) Pair RockvilIe RMC80W 8\" 800 Watt Waterproof Marine Boat Speakers 2-Way White. (1)RockvilIe RMWK4 4 AWG Gauge Waterproof Marine Amplifier/Amp Install Wire Kit. (1) RockvilIe RXM-F4 Marine 4 Channel Amplifier 2400 Watt/1200w RMS+PA Microphone. What\'s Included: Pair of 8\" marine speakers. 16.4 feet of Speaker Wire. Mounting Screws. Features:
- RockvilIe RMC80W 8 2-Way 800 Watt Marine Boat Speakers in White (Pair). CEA Compliant Power Ratings. Power Rating: 400 Watts Peak /100 Watts RMS Per Speaker. System Power: 800 Watts Combined. 8 2-Way Speaker System. Fully Marinized Against Salt & Fresh Water Conditions. Completely Waterproof and rustproof. Stainless Steel Terminals. Molded ABS plastic basket. Polypropylene Mica Injected Cone. Rubber Surround. High quality ferrite magnet. 13mm (0.5 inch) Polymer Tweeter
- Oversized 1 CCAW Kapton Voice Coil. Pre-installed mounting screws included. Perfect for both marine, outdoor, and car use. Impedance: 4 Ohms. Frequency Response: 40Hz - 20KHz. Sound Pressure Level: 91dB @ 1w/1m. Total Diameter: 9.65. Cutout Diameter: 7.36. Total Height: 4.8. Mounting Depth: 3.54\". New Page 4. Includes: Amplifier. PA Microphone. High Level Input Wire. Mounting Screws. RockvilIe RXM-F4 Marine 4 Channel Amplifier. 2400 Watt Peak/1200w RMS. PA Microphone Included
- CEA Compliant Power Ratings: 400 Watts (4 x 100 Watts) at 4 ohms and 1% THD+N 600 Watts (4 x 150 Watts) at 2 ohms < 1% THD 2 x 300 Watts bridged @ 4 Ohms < 1% THD. 400 Watts (4 x 100 Watts) at 4 ohms and 1% THD+N. 600 Watts (4 x 150 Watts) at 2 ohms < 1% THD. 2 x 300 Watts bridged @ 4 Ohms < 1% THD. RMS Power Ratings 1200 Watts (4 x 300 Watts RMS) @ 2 ohms 1200 Watts (2 x 600 Watts RMS) @ 4 ohm Bridged 800 Watts (4 x 200 Watts RMS) @ 4 ohms. 1200 Watts (4 x 300 Watts RMS) @ 2 ohms
- 1200 Watts (2 x 600 Watts RMS) @ 4 ohm Bridged. 800 Watts (4 x 200 Watts RMS) @ 4 ohms. Peak Power: 2400 Watts (2 x 1200 @ 2 ohms or 1 x 2400 @ 4 Ohms). High-Speed MOSFET Power Supply. Studio-Grade Bipolar Output Stage Transistors. Fully Adjustable 12dB / Octave Crossover with Differential Circuitry. CH3 & CH4 Low Pass 50Hz - 3KHz. CH3 & CH4 High Pass 15Hz - 1KHz. CH1 & CH2 High Pass 50Hz - 300Hz, 500Hz - 3Khz (x10). High Level Input Auto Start Smart Turn-On
2 Ohm: 150 Watts x 4 Channels <1% THD+N @ 14.4 Volts. 4 Ohm: 100 Watts x 4 Channels <1% THD+N @ 14.4 Volts. 4 Ohm Bridged: 300 Watts x 2 Channels <1% THD @ 14.4 Volts. Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc). 2 Ohm: 600 Watts x 4 Channels. 4 Ohm: 400 Watts x 4 Channels. 4 Ohm Bridged: 1200 Watts x 2 Channels. Painted Conformal Coating PCB Board (Uses 2577 Waterproof Glue). Rustproof Aluminum heat sink with black hairline finish. Stainless steel end panels are rustproof. All screws and mounting hardware are stainless steel and rustproof. Bottom panel is aluminum and rustproof. Marine public address system with microphone with talkover function. All channels on the amp have crossovers so they can each be used for subs or full range speakers or tweeters or midrange speakers. All channels on the amplifier are bridgeable. Digital Voltage Display on Amp. Fully Adjustable 12dB / Octave Crossover with Differential Circuitry. Adjustable Subsonic Filter: 15Hz -40Hz (This filter is on the HPF knob). Adjustable Low Pass Filter: 40Hz - 4KHz. Adjustable Band Pass Filter: 15 Hz - 4 kHz (use both the HPF and LPF filter). Adjustable High Pass (Subsonic) Filter: 15 Hz - 4 kHz. 2CH/4CH Input Mode Switch. 8 Volt Preamp Circuitry. Under Voltage Protection at 10V. Over Voltage Protection at 16V. High-Speed MOSFET Power Supply. Full IC-Controlled Protection Circuitry. Fully Adjustable 12dB Bass Equalizer. Adjustable Input Level Control. Studio-Grade Bipolar Output Stage Transistors. Mute and Delay Soft Start System. Status Mode LED Indicators. Minimum THD at Rated Power: <0.05%. S / N Ratio: >90dB.